UT Electronic Music Studios - Studio III

Useful Information for Users of the PC

Audio Interface Information:

The PC uses a Steinberg Nuendo Audio Interface. This interface is a re-branded version of an interface made by RME. It is connected digitally (ADAT Optical Lightpipe) to the ZSYS Optipatch digital patchbay. Information about the interface can be found here under Hammerfall DSP:

RME Tech Support

Setting Up the Studio to Use the PC

  1. Make sure that the ZSYS is setup properly. The Nuendo ADAT I/O needs to be connected to Card 1 of the 02R (5 to 1). And, Card 1 of the 02R needs to be connected to the Nuendo ADAT (1 to 5). Preset "00" can be loaded to make these connections.

  2. The Yamaha 02R should have its clock set to internal (either 44.1 KHz or 48 KHz). This is accomplished in page 1 of the Digital I/O section of the mixer. (Look under DISPLAY ACCESS on the mixing console).

  3. In the system tray, open the Hammerfall DSP utility. Make sure it is set to sync externally via ADAT I/O.

  4. Card 1 of O2R comes in via Tape inputs 1-8. To access these channels, it is easiest to hit the flip button, which swaps the pots functionality with the faders.

Using the PC