MIDI Setup in EMS 1

MIDI device assignments on the MTP-AV

1 - Yamaha 01V Mixer

2 - ADAT Sync (in only)

3 - Yamaha DX7

4 - Yamaha MU50

5 - Alesis Quadraverb

6 - Yamaha TX4-16 Common

7 - Kurzweil K2000

8 - Front panel connector (unassigned)

Assigning Devices in Cubase SX

1. Click on the "Devices" menu at the top of the screen, and then "MIDI Device Manager"
2. Then in the pop-up window, click "Install Device"
3. Scroll down and select "DX7 II (Yamaha)"
4. Click "Install Device" again and select "MU 50 (Yamaha)" and once again selecting "K2000 (Kurzweil)"
5. After all 3 have been listed in the "Installed Devices" column in the "MIDI Device Manager,
6. Highlight each one and change the "Output" box (black box sort of in the middle) to the following:

• DX7 - Port 3 on MTPAV (Emulated)
• MU 50 - Port 4 on MTPAV (Emulated)
• K2000 - Port 7 on MTPAV (Emulated)

7. Close the "MIDI Device Manager" and go back to your project.

Notes:

• Once you do this in your own MML account, you should never need to do this again.
• In any MIDI track that you create, you can now assign the "Out" to any of the three synths we just defined.
• In additon, after selecting a particular synth, we can pick individual sounds by clicking on the bank tab
• (by default it says "Off" and is located right below the "out" and "channel" tabs.
• When working with different sounds to be played on the same device, be sure to select different channels!